- 您现在的位置：买卖IC网 > Sheet目录313 > AT28C010E-20TI (Atmel)IC EEPROM 1MBIT 200NS 32TSOP
4.5
Toggle Bit
In addition to DATA Polling the AT28C010 provides another method for determining the end of a
write cycle. During the write operation, successive attempts to read data from the device will
result in I/O6 toggling between one and zero. Once the write has completed, I/O6 will stop tog-
gling and valid data will be read. Reading the toggle bit may begin at any time during the write
cycle.
4.6
4.6.1
4.6.2
4.7
4.8
4
Data Protection
If precautions are not taken, inadvertent writes may occur during transitions of the host system
power supply. Atmel ? has incorporated both hardware and software features that will protect the
memory against inadvertent writes.
Hardware Protection
Hardware features protect against inadvertent writes to the AT28C010 in the following ways: (a)
V CC sense – if V CC is below 3.8V (typical) the write function is inhibited; (b) V CC power-on delay –
once V CC has reached 3.8V the device will automatically time out 5 ms (typical) before allowing
a write; (c) write inhibit – holding any one of OE low, CE high or WE high inhibits write cycles;
and (d) noise filter—pulses of less than 15 ns (typical) on the WE or CE inputs will not initiate a
write cycle.
Software Data Protection
A software controlled data protection feature has been implemented on the AT28C010. When
enabled, the software data protection (SDP), will prevent inadvertent writes. The SDP feature
may be enabled or disabled by the user; the AT28C010 is shipped from Atmel with SDP
disabled.
SDP is enabled by the host system issuing a series of three write commands; three specific
bytes of data are written to three specific addresses (refer to Software Data Protection Algo-
rithm). After writing the 3-byte command sequence and after t WC the entire AT28C010 will be
protected against inadvertent write operations. It should be noted, that once protected the host
may still perform a byte or page write to the AT28C010. This is done by preceding the data to be
written by the same 3-byte command sequence used to enable SDP.
Once set, SDP will remain active unless the disable command sequence is issued. Power transi-
tions do not disable SDP and SDP will protect the AT28C010 during power-up and power-down
conditions. All command sequences must conform to the page write timing specifications. The
data in the enable and disable command sequences is not written to the device and the memory
addresses used in the sequence may be written with data in either a byte or page write
operation.
After setting SDP, any attempt to write to the device without the 3-byte command sequence will
start the internal write timers. No data will be written to the device; however, for the duration of
t WC , read operations will effectively be polling operations.
Device Identification
An extra 128 bytes of EEPROM memory are available to the user for device identification. By
raising A9 to 12V ± 0.5V and using address locations 1FF80H to 1FFFFH the bytes may be writ-
ten to or read from in the same manner as the regular memory array.
Optional Chip Erase Mode
The entire device can be erased using a 6-byte software code. Please see Software Chip Erase
application note for details.
AT28C010
0353I–PEEPR–08/09
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
AT28C16E-15SC
IC EEPROM 16KBIT 150NS 24SOIC
AT28C17E-15SI
IC EEPROM 16KBIT 150NS 28SOIC
AT28C256E-15TI
IC EEPROM 256KBIT 150NS 28TSOP
AT28C64B-15SU
IC EEPROM 64KBIT 150NS 28SOIC
AT28C64E-25TI
IC EEPROM 64KBIT 250NS 28TSOP
AT28C64X-25SI
IC EEPROM 64KBIT 250NS 28SOIC
AT28HC256E-70TU
IC EEPROM 256KBIT 70NS 28TSOP
AT28HC64B-70TU
IC EEPROM 64KBIT 70NS 28TSOP
相关代理商/技术参数
AT28C010E-20UM/883
制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:1 Megabit 128K x 8 Paged CMOS E2PROM
AT28C010E-25BM/883
制造商:Atmel Corporation 功能描述:250NS SDBRZ 883C, LEV B COMPLIANT - Rail/Tube
AT28C010E-25DM/883
制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:1 Megabit 128K x 8 Paged CMOS E2PROM
AT28C010E-25EM/883
制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:1-Megabit (128K x 8) Paged Parallel EEPROMs
AT28C010E-25LM/883
功能描述:电可擦除可编程只读存储器 Parallel 电可擦除可编程只读存储器 5V-200NS, 883c
RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8
AT28C010E-25UM/883
制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:1 Megabit 128K x 8 Paged CMOS E2PROM
AT28C010-W
制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:1 Megabit 128K x 8 Paged CMOS E2PROM
AT28C-01DB0.3BLF
制造商:AAC 制造商全称:American Accurate Components, Inc. 功能描述:SMD Chip Attenuator